Link Search Menu Expand Document

East-West Connection Tool

The East-West Connection Tool draws a connection line that originates from the side (either west/left or east/right) of the source figure and connects to the side (either west/left or east/right) of the target figure. To select the East-West Connection Tool, perform the following steps:

Step 1: Click on the Connection Type Tab within the Sidebar and choose the East-West Connection Tool.

Step 2: Then click on the Connection Tool within the Drawing Toolbar.

This connection between the figures is created in the same manner as with the Line Connection Tool, but the connection path remains orthogonal with the source and target lines remaining horizontal.

Perform a Click/Drag combination from the desired starting point on a figure to the desired end point on another figure and then release the Click action to complete the connection. The selected figures will be highlighted in blue when a valid connection has been made. Refer to the images below:

The completed connection line will appear as shown below:

How to Change the Corner Size

The created connection line will automatically contain squared (90-degree angle) corners.

To change the Corner Size, select the created connection line and click on the Geometry Tab in the Sidebar. Then alter the Corner Size value by clicking on the Up and Down buttons.

Changing the Corner Size to 0.25 inches for a selected connection line causes the corners to be rounded, as shown below.

Note: Performing a Click/Drag combination on the second figure after the connection is established results in the connection line position being adapted to keep the two figures connected.


Copyright © 2010-2022 Elevenworks LLC. All rights reserved.